User Manual

Prepare to Leave the Site – continued
5-12 1X SC4812T–MC BTS Optimization/ATP 5/21/04
DRAFT
Table 5-5: Set GLI3 Span Parameter Configuration
Step Action
14
* IMPORTANT
S After executing the config ni format, config ni linkspeed, and/or config ni equal commands,
the affected MGLI/GLI board MUST be reset and reloaded for changes to take effect.
S Although defaults are shown in the software, always consult site–specific documentation for span
type, equalization, and linkspeed used at the site where the cards are to be installed.
Reset the card using the MMI reset command.
15 Once the card has completed resetting, execute the following command to verify span settings are as
required:
config ni current
A response similar to the following will be displayed :
The frame format in flash is set to use T1_2.
Equalization:
Span A – 0–131 feet
Span B – 0–131 feet
Span C – Default (0–131 feet for T1/J1, 120 Ohm for E1)
Span D – Default (0–131 feet for T1/J1, 120 Ohm for E1)
Span E – Default (0–131 feet for T1/J1, 120 Ohm for E1)
Span F – Default (0–131 feet for T1/J1, 120 Ohm for E1)
Linkspeed: 64K
Currently, the link is running at 64K
The actual rate is 0
16 If the span configuration is not correct, perform the applicable step from this table to change it and
repeat steps 14 and 15 to verify required changes have been programmed.
17 Repeat steps 1 through 16 for each GLI card requiring changes in the span parameter settings.
18 If no other MMI actions are required for the card, terminate the MMI communication session and
disconnect the LMF computer from the card.
LMF Removal
DO NOT power down the LMF without performing the
procedure below. Corrupted/lost data files may result, and
in some cases, the LMF may lock up.
NOTE
Follow the procedure in Table 5-6 to terminate the LMF session and
remove the terminal.
5