User Manual

Prepare to Leave the Site – continued
5/21/04 1X SC4812T–MC BTS Optimization/ATP 5-11
DRAFT
Table 5-5: Set GLI3 Span Parameter Configuration
Step Action
10 At the entry prompt (>), enter the code for the required equalization from the list as shown in the
following example (this should be the distance from the BTS Span I/O to the site demarcation
equipment or CSU, as applicable):
> 0
A response similar to the following will be displayed :
> 0
The value has been programmed. It will take effect after the next reset.
GLI2>
11 Repeat steps 8 through 10 for each in–use span.
12
! CAUTION
Do not set the card for loopback as described in this step unless specifically required or requested for
testing.
Enter the following MMI command to turn loopback on or off:
GLI#> config ni loopback <on or off>
Loopback commands and responses:
GLI#> config ni loopback on
Loopback request SUCCESSFUL: All framers have been placed in loopback.
They will remain in loopback for 1 hour.
GLI#> config ni loopback off
Loopback request SUCCESSFUL: All framers have been removed from loopback.
13
NOTE
This step must be performed for GLI3 cards operating on a packet image to ensure the span parameter
changes will replace the previous settings.
For a GLI3 card in packet mode, enter the following:
rmfile /nvram00/config/hlp_param.txt
A response similar to the following will be displayed :
GLI3> rmfile /nvram00/config/hlp_param.txt
11.24.2003 23:14:57 MGLI–004–1 CC PRESENT BTS–CDMA 16.40.00.09
Removing file: /nvram00/config/hlp_param.txt
Successfully removed file: /nvram00/config/hlp_param.txt
GLI3>
. . . continued on next page
5