User Manual

Prepare to Leave the Site – continued

5-8 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

Table 5-5: Set GLI3 Span Parameter Configuration

Step Action

If the current MGLI/GLI span rate must be changed, enter the following MMI command:

config ni linkspeed

A response similar to the following will be displayed :

Next available options:

LIST – linkspeed : Span Linkspeed

56K : 56K (default for T1_1 and T1_3 systems)

64K : 64K (default for all other span configurations)

NOTE

With this command, all active (in–use) spans will be set to the same linkspeed.

To set or change the span linkspeed, enter the required option from the list at the entry prompt (>), as

shown in the following example:

> 64K

NOTE

The entry is case–sensitive and must be typed exactly as it appears in the list. If the entry is typed

incorrectly, a response similar to the following will be displayed:

CP: Invalid command

01.061980 00:12’04 MGLI–000–2 INS–ACT BTS–CDMA 16.1.68.00

GLI3>

7 An acknowledgement similar to the following will be displayed:

The value has been programmed. It will take effect after the next reset.

GLI3>

. . . continued on next page