User Manual

Prepare to Leave the Site – continued

5/21/04 1X SC4812T–MC BTS Optimization/ATP 5-7

DRAFT

Table 5-5: Set GLI3 Span Parameter Configuration

Step Action

1 If it has not been done, start a GLI3 MMI communication session on the LMF computer as described

in Table 3-10.

At the GLI3> prompt, enter the following:

config ni format

The terminal will display a response similar to the following:

COMMAND SYNTAX: config ni format option

Next available options:

LIST – option : Span Option

E1_1 : E1_1 – E1 HDB3 CRC4 no TS16

E1_2 : E1_2 – E1 HDB3 no CRC4 no TS16

E1_3 : E1_3 – E1 HDB3 CRC4 TS16

E1_4 : E1_4 – E1 HDB3 no CRC4 TS16

T1_1 : T1_1 – D4, AMI, No ZCS

T1_2 : T1_2 – ESF, B8ZS

J1_1 : J1_1 – ESF, B8ZS (Japan) – Default

J1_2 : J1_2 – ESF, B8ZS

T1_3 : T1_3 – D4, AMI, ZCS

NOTE

With this command, all active (in–use) spans will be set to the same format.

To set or change the span type, enter the correct option from the list at the entry prompt (>), as shown

in the following example:

> T1_2

NOTE

The entry is case–sensitive and must be typed exactly as it appears in the list. If the entry is typed

incorrectly, a response similar to the following will be displayed:

CP: Invalid command

01.061980 00:11’59 MGLI–000–2 INS–ACT BTS–CDMA 16.1.68.00

GLI3>

4 An acknowledgement similar to the following will be displayed:

The value has been programmed. It will take effect after the next reset.

GLI3>

. . . continued on next page