User Manual

Prepare to Leave the Site – continued

5/21/04 1X SC4812T–MC BTS Optimization/ATP 5-5

DRAFT

Table 5-4: BTS Span Parameter Configuration

Step Action

1 Connect a serial cable from the LMF COM1 port (via null modem board) to the front panel of the

MGLI MMI port (see Figure 5-1).

2 Start an MMI communication session with MGLI by using the Windows desktop shortcut icon (see

Table 3-3 on page 3-11).

NOTE

The LMF program must not be running when a Hyperterminal session is started if COM1 is being

used for the MMI session.

Verify the span parameter settings for frame format, equalization, and linkspeed for the span to be used

by entering the following at the

GLI3> prompt:

config ni current

The system will respond with a display similar to the following:

The frame format in flash is set to use T1_2.

Equalization:

Span A – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span B – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span C – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span D – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span E – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span F – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Linkspeed: Default (56K for T1 D4 AMI, 64K otherwise)

Currently, the link is running at the default rate

The actual rate is 0

NOTE

S Defaults for span equalization are 0–131 feet for T1/J1 spans and 120 Ohm for E1.

S Default linkspeed is 56K for T1 D4 AMI spans and 64K for all other types.

S There is no need to change from defaults unless the provisioned span configuration requires it.

4 The span parameter settings in the GLI must match those provisioned in the OMC–R database for the

BTS. If they do not, proceed to Table 5-5 to change the span parameter settings.

5 Repeat steps 1 through 4 for all remaining GLIs.

6 Exit the GLI MMI session and HyperTerminal connection by selecting File from the connection

window menu bar, and then Exit from the drop–down menu.