User Manual

Prepare to Leave the Site

5-4 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

External Test Equipment

Removal

Perform the procedure in Table 5-3 to disconnect the test equipment and

configure the BTS for active service.

Table 5-3: External Test Equipment Removal

Step Action

1 Disconnect all external test equipment from all TX and RX

connectors on the top of the frame.

2 Reconnect and visually inspect all TX and RX antenna feed

lines at the top of the frame.

Verify that all sector antenna feed lines are connected to

the correct ports on the frame. Crossed antenna cables will

cause system degradation of call processing.

CAUTION

Each module or device can be in any state prior to

downloading. Each module or device will be in an

OOS_RAM state after downloading has completed.

S For all LMF commands, information in italics

represents valid ranges for that command field.

S Only those fields requiring an input will be specified.

Default values for other fields will be assumed.

S For more complete command examples (including

system response details), refer to the CDMA LMF User

Guide.

NOTE

BTS Site Span Configuration

Verification

Perform the procedure in Table 5-4 to verify the current Span Framing

Format and Line Build Out (LBO) parameters. ALL MGLI/GLI boards

in all C–CCP shelves that terminate a T1/E1 span should be verified.