User's Manual

ATP Tools and Materials – continued

JAN 2002

1-15

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

DRAFT

Communications Test Set

This procedure requires one of the following test sets:

 Motorola CyberTest

 Advantest R3465 and HP 437B or Gigatronics 8541C Power Meter

 Hewlett–Packard HP 8935

 Hewlett–Packard HP8921 (w/CDMA and PCS interface for 1.7/1.9

GHz) and HP 437B or Gigatronics Power Meter.

4–port 10 Base T ethernet hub (optional)

One 4–port, 10 base T, 10 Mbps, ethernet hub with BNC connector.

This is used for LMF to BTS ethernet connections. This is used to

connect the PCMCIA serial I/O port of the LMF to the RJ45 ethernet

cable.

GPIB cables

Two Hewlett Packard 10833A or equivalent; 1 or 2 meters long used to

interconnect test equipment and LMF terminal.

Power meter

This procedure requires one of the following power meters:

 Gigatronics Model 8541C with 80601A power sensor capable of

measuring from –70 dBm to +23 dBm; supported by the LMF to

perform BTS Total Power measurement.

 Hewlett–Packard Model HP437B with HP8481A power sensor

capable of measuring from –30 dBm to 20 dBm.

RF attenuators

30 dB, 10 Watt minimum RF attenuator to attenuate the transmitter

output for MicroCell tests.

BTS serial cable

One BTS serial cable to connect LMF to MMI/LMF connector.

Male N to male N cables

The following male N to male N cables are necessary to do this

procedure:

 One male N to male N cable. The short RF test cable used for cable

calibration.

 Two male N to male N cables. The transmit RF test cable and the

receive RF test cable used for ATP.

Male BNC to male N cable

One male BNC to male N cable. This cable is used to allow

self–calibration of the Communication Test Set.