User's Manual

Attaching Unit to Mounting Bracket – continued

JAN 2002

6-9

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

DRAFT

Table 6-4: Procedure to Attach the Unit to the Mounting Bracket

Step Action

3 At the bottom of the unit, align the hole in the mounting bracket with the hole in the unit. Place

the pin or customer–supplied padlock through this hole. Screw pin together and tighten firmly.

4 Use a T30 Torx tamper bit to torque the two mounting screws to 5.0 N–M.

5 Use a T30 Torx tamper bit to remove the installation handles.

Figure 6-6: Attaching Unit to V–Style Mounting Bracket

ATTACH THE HANDLES TO

THE UNIT BEFORE LIFTING

HOOKS

MOUNTING

BRACKET

SLIDE PIN THROUGH

HOLES IN BRACKET AND

SCREW TOGETHER

M6 SCREWS (2)

LOCKING INTERFACE

MOUNTING BRACKET

PIN (P/N 5587660C01 OR,

5587660C02)