User's Manual

Cable Descriptions

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

4-2

Cable Descriptions and Part

Numbers

Table 4-1 gives the cable descriptions and part numbers for the cables

used to install the BTS. The following cables are necessary for sites

equipped with the customer–supplied Site I/O Interface and the Primary

Surge Suppressor.

Table 4-1: Cable Descriptions and Part Numbers

Cable Qty. Part Number Description

A 1 3087701C02 Ground cable, 8 -AWG, insulated copper wire. Requires one ring lug

connector. Used for Primary Surge Suppressor Installation.

B 1–4 3087701C01 Ground cable. Installed between Site I/O Junction Box and Mounting

Bracket.

C 1–8 Customer

Supplied

Antenna cable, 50–Ohm coaxial terminated with at least one male,

N–type connector.

D 2–6 Customer

Supplied

Antenna cable, terminated with 2 male N–type connectors

E 1* 3087707C03 MIB A cable (current, 2m; micro) (part of kit T448H, T448G and

T448A)

F 1* 3087707C04 MIB B cable (current, 2m) (part of kit T448AR, T448AY, and T448H)

G 2* 3087707C05 MIB C cable (current, 2m) (part of kit T448H)

I 1* 3087707C07 MIB B cable (long, 5m) (part of kit T448AS, T448AZ, and T448G)

J 2* 3087707C08 MIB C cable (long, 5m) (part of kit T448G)

K 1* 3087707C09 MIB A cable (short, 1m; micro) (part of kit T448B)

L 1–4 3087701C04 Y–Ground cable (for Site I/O and external SU)

M 1

3086039H11 RGPS cable, 125 ft.

3086039H12 RGPS cable, 250 ft.

3086039H13 RGPS cable, 500 ft.

3086039H14 RGPS cable, 1000 ft.

3086039H15 RGPS cable, 2000 ft.

N 1 Customer

Supplied

Span cable. 22–24 AWG solid copper twisted pair.

O 1 Customer

Supplied

Customer Input cable. 22–24 AWG solid copper twisted pair.

P 1–4 3088120C03 SU RF cable

Q 1 – SU Digital Cable

. . . continued on next page