User's Manual
GPIB Addresses – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-48
Table 7-27: Verify and Change Agilent E4406A GPIB Address
Step Action
3b
On the front panel Data Entry keypad, enter the communications system analyzer GPIB address of 18.
– The GPIB Address label will change to Enter.
– Digits entered with the keypad will replace the current GPIB address in the display.
NOTE
To correct an entry, press the Bk Sp key at the upper right of the keypad to delete one character at a
time.
3c Press the Enter softkey button or the keypad Enter key to set the new GPIB address.
– The Config I/O softkey labels will re–appear.
– The new GPIB address will display under the GPIB Address softkey label.
Figure 7-25: Setting Agilent E4406A GPIB Address
System
Key
Bk Sp
Key
Enter
Key
Data Entry
Keypad
Softkey
Buttons
Softkey Label
Display Area
Active Function
Area
7