User's Manual
GPIB Addresses – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-46
Table 7-26: Verify and Change Advantest R3267 GPIB Address
Step Action
3b
Enter 18 on the keypad in the ENTRY section of the instrument front panel.
– Characters typed on the keypad will replace the address displayed in the GPIB Address entry
window.
NOTE
To correct an entry, press the BS (backspace) key at the lower right of the keypad to delete one
character at a time.
3c Press the ENTR key to the lower right of the keypad to enter the address.
– The GPIB Address entry window closes.
– The new address is displayed in the bottom portion of the GPIB Address softkey label.
Figure 7-23: Setting Advantest R3267 GPIB Address
o
n
REMOTE
LED
LCL Key
CONFIG
Key
Softkey Label
Display Area
Softkey
Buttons
Keypad BS
Key
ENTR
Key
7