User's Manual

GPIB Addresses – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-42
Verify and Set HP8935 Test Set
GPIB Address
Follow the procedure in Table 7-23 to verify and, if necessary, change
the HP8935 GPIB address.
Table 7-23: Verify and/or Change HP8935 GPIB Address
Step Action
1
* IMPORTANT
The HP I/O configuration MUST be set to Talk & Listen, or NO device on the GPIB bus will be
accessible (if necessary, consult test equipment OEM documentation for additional information).
To verify that the GPIB addresses are set correctly, press Shift and LOCAL on the HP8935 (refer
to Figure 7-19). The current HP–IB address will display at the top of the screen.
NOTE
HP–IB is the same as GPIB.
2 If the current GPIB address is not set to 18, perform the following steps to change it:
– Press Shift and Inst Config.
– Turn the Cursor Control knob to move the cursor to the HP–IB Adrs field.
– Press the Cursor Control knob to select the field.
– Turn the Cursor Control knob as required to change the address to 18.
– Press the Cursor Control knob to set the address.
3 Press Preset to return to normal operation.
Figure 7-19: HP8935 Test Set
FW00885
Preset
Cursor Control
Shift
Inst Config
Local
7