User's Manual

BTS Software – continued

JAN 2002

7-35

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

DRAFT

Table 7-17: Procedure to Download/Enable MAWI

Step Action

4 Click on the MAWI and select Device>Download>Code Data. A status report is displayed that

confirms the change in device status. Click OK to close status window.

5 Click on the MAWI and select Device>Enable to enable the MAWI. The MAWI changes to green

(INS–ACT test mode).

NOTENOTE

The LMF may fail this step. After you enable the MAWI, verify that the LED on the SC300 changes

to a solid green, then click on the STOP radio button to halt the ENABLE command. Run the

STATUS MAWI command and the display will change to the INS_ACT (green) state.

Configuration Data File (CDF)

The Configuration Data File (CDF) includes the CDMA channel element

allocation plan. This plan indicates how each CDMA carrier is

configured, and how the paging, sync, traffic, and access channel

elements (and associated gain values) are assigned.

The CDF file also contains a table for the Effective Rated Power (ERP)

for each transmit antenna. Motorola System Engineering specifies the

ERP of a transmit antenna based on site geography, antenna placement,

and government regulations. Working from this ERP requirement, the

antenna gain, (dependent on the units of measurement specified) and

antenna feed line loss can be combined to determine the required power

at the BTS TX output.

Refer to the CDMA LMF Operators Guide; 68P64114A78

for additional information on the layout of the LMF

directory structure (including cdf file locations and

formats).

NOTE

Site equipage verification

If you have not already done so, use an editor to view the CDF, and

review the site documentation. Verify the site engineering equipage data

in the CDF to the actual site hardware.

If the current LMF or BTS binaries need to be installed on

the LMF PC, or for more information on viewing CDF

files, refer to the CDMA LMF Operators Guide;

68P64114A78.

NOTE