User's Manual
BTS Software – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-34
Table 7-16: Procedure to Update BTS–Specific CDF File Device Load Version
Step Action
3 Select CDMA.
4 Select the BTS number from the list of available base stations.
5 Select the radio button next to the desired version number.
6 Click on the Save button. A pop–up message will appear indicating that “This action may
take a few seconds.” Click on the OK button.
7 A pop–up message will appear indicating that the NextLoad file has been updated.
NOTENOTE
At this point, a backup copy of the original CDF is created with a _bak extension, (e.g.,
bts–812.cdf_bak ).
8 Click on the OK button to dismiss the pop–up message.
Download/Enable MAWI
The objective of this procedure is to download and enable the BTS.
The BTS software platform is based on the Motorola Advanced
Wideband Interface (MAWI). The term MAWI is used to refer to the
MicroCell from the LMF’s point of view.
The BTS is shipped from the factory with all the software
downloaded. Use the load procedure only when new
software is loaded.
NOTE
Follow the steps outlined in Table 7-17 to download the code and data to
enable the MAWI.
Before the download/enable process, use the status function and verify
the MAWI responds with status information. Use this information to get
the current code loaded in MAWI.
Table 7-17: Procedure to Download/Enable MAWI
Step Action
1 If the ATP is going to be run, the MAWI has to have the same code load as the LMF CDF or the site
specific information cannot be loaded to MAWI (PN offset, etc.) for ATP to complete.
2 If downloading code, insure the LMF is logged into the BTS at 38400 Baud Rate for timely
download (20 minutes vs 2+ hours).
3 Click on the MAWI and select Device>Download>Code Manual.
A status report is displayed that confirms the change in device status. Click OK to close status
window.
. . . continued on next page
7