Service Manual

GSM-205-323
Stacking bracket and CCB basket
31st Oct 01
Tech. 2–14
Technical Description: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W07-B
Stacking bracket and CCB basket
Stacking
bracket function
The stacking bracket has two main functions:
 To enable a second cabinet to be stacked on top of the first cabinet.
 To house CCBs in a dedicated optional CCB basket.
The stacking bracket is fixed to the top of the cabinet by eight M8 screws. If the
stacking bracket is replacing an existing hood, then the four hood securing pins
must first be removed to accommodate four of the stacking bracket screws. A
second cabinet may be attached on top of the stacking bracket by four M10
screws.
Lower cabinet outlet and additional upper cabinet inlet ventilation is provided by
the large open sides of the stacking bracket (especially on the right side of the
cabinet).
The CCB basket is fitted only if CCBs are required. The CCB basket is
removable, to enable access for SURF module replacement.
Stacking
bracket diagram
Figure 2-12 shows a view of the stacking bracket with CCB basket installed.
ig.268.rh
M8 HOLES (8) FOR
BOTTOM CABINET
ATTACHMENT.
M10 HOLES (4) FOR TOP CABINET
ATTACHMENT (IF REQUIRED)
CCB BASKET
(IF REQUIRED)
DETACHABLE
CCB BASKET BAR
REAR OF
BRACKET
Figure 2-12 View of stacking bracket with CCB basket installed.