Service Manual

GSM-205-523
Replacing a stacking bracket
31st Oct 01
Maint. 2–10
Maintenance Information: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W09-B
Procedure to
replace a
stacking
bracket
Replace the stacking bracket as follows:
1. Remove the front cover by pulling away.
WARNING The cabinet can weigh as much as 115 kg with the hood
fitted. Observe correct lifting precautions.
2. If an upper cabinet is fitted on top of stacking bracket, decommission the
cabinet as described in
Installation and Configuration: (GSM-205-423)
Chapter 4 Decommissioning Horizon macro indoor.
3. If a CCB is fitted, remove it (see Replacing a CCB).
4. Loosen and remove the eight M8 screws holding the faulty bracket.
WARNING
The stacking bracket can weigh as much as 15 kg (more if
CCB is contained in CCB basket). Observe the correct
lifting precautions.
5. Lift the faulty stacking bracket off the cabinet.
6. Align the replacement stacking bracket onto the cabinet, and fit the eight
M8 screws. Tighten to correct torque (see Overview of replacement
procedures).
7. Install and commission any upper cabinet removed in step 2 as described
in
Installation and Configuration: (GSM-205-423) Chapter 2 and Chapter
3.
8. Refit the front cover by attaching to side lugs and pushing into position.