Service Manual

GSM-205-523
Replacing a hood
31st Oct 01
Maint. 2–8
Maintenance Information: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W09-B
Replacing a hood
Introduction to
hood
replacement
This procedure assumes an optional hood is already fitted, with hood pins
located in the correct cabinet locations. If the hood is to replace a stacking
bracket, refer to the appropriate procedures in this chapter Replacing a
stacking bracket and
Installation and Configuration: (GSM number) Chapter 2,
Hood or stacking bracket fit.
View of hood
Figure 2-3 shows a top view of the hood.
ig.333.rh
LIFTING EDGE
HOOD
TOP SECTION OF
CABINET DOOR
Figure 2-3 Hood view when placed on top of cabinet
Replacing the
hood
The hood is held in place by four pins. Remove the faulty hood by lifting the
edge, until free of the pins.
To fit the replacement hood, first align the hood to the back pins, then lower the
hood onto the pins and press firmly into place.