Service Manual

GSM-205-523
Replacing a door
31st Oct 01
Maint. 2–6
Maintenance Information: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W09-B
Replacement of
door
Removing a faulty door
To remove a door, open and:
1. At the cabinet, unscrew M6 nut, holding the door earth cable to the
cabinet. Retain nut for re-use.
2. Unscrew M6 holding screw on slide arm several turns, then unhook slide
arm from the cabinet attachment point by lifting up.
3. Move door to about 90° and lift door off hinges.
Fitting a replacement door
CAUTION Avoid damaging the honeycomb door vent.
To install a replacement door:
1. Hold door at about 90° and lift onto door hinges.
2. Attach the door earth cable to the cabinet by using the M6 nut. Tighten to
the correct torque (see Overview of replacement procedures).
3. Place the slide arm onto the cabinet attachment holding point and apply
several turns of the M6 holding screw.