Service Manual

GSM-205-523
Routine maintenance overview
31st Oct 01
Maint. 1–4
Maintenance Information: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W09-B
Stacking
bracket front
cover removal
and fit
The stacking bracket front cover is attached to the stacking bracket by four
locating clips.
To remove a stacking bracket refer to Figure 1-1 and then remove the stacking
bracket front cover by applying gentle pressure to the outer edges, while easing
the cover up and pulling it away from the bracket.
REMOVAL
FITTING
FRONT
COVER
STACKING
BRACKET
Lift and pull
Apply gentle
pressure
Apply gentle
pressure
ig.334.rh
Figure 1-1 Removing and fitting the stacking bracket front cover
To fit the front cover:
1. Align the four locating clips on the front cover with the four square holes in
the front of the stacking bracket. Ensure that the cut out slot on each clip
is facing downward.
2. Press the cover against the stacking bracket, so that the cut out slot on
each locating clip engages with the bottom edge of each square hole. It
may be necessary to gently push in and down to ensure the cut out slots
are fully engaged and the cover securely in place.