Service Manual

GSM-205-423
Decommissioning Horizonmacro indoor
31st Oct 01
Inst. 5–8
Installation & Configuration: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W08-B
Removing floor
mounted
cabinet
WARNING The cabinet can weigh up to 130 kg if fully equipped.
Handle each cabinet with extreme caution, and in
accordance with local health and safety regulations.
Horizon
macro cabinets are heavy and should not be
installed without the use of lifting equipment unless
sufficient personnel are available to ensure that Health
and Safety regulations are not breached.
To remove a floor mounted cabinet for decommissioning:
1. Unscrew the two front bolts holding the cabinet to the plinth.
2. Slide the cabinet out of the plinth.
3. Unscrew the plinth anchor bolts and lift the plinth from the floor.
4. Carefully pack all bolts, washers and other removed items.
5. Pack the cabinet and plinth in separate containers, for storage, transport
or safe disposal.
Returning
equipment to
Motorola
If sending equipment back to Motorola, seal the shipping containers and return,
as advised, by the Motorola in-country project manager.