Service Manual

GSM-205-423
Decommissioning Horizonmacro indoor
31st Oct 01
Installation & Configuration: Horizon macro indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 5–7
Removing a
stacking
bracket
To remove a stacking bracket:
1. Remove the stacking bracket front cover by applying gentle pressure to
the outer edges, while easing the cover up and pulling it away from the
bracket.
Figure 5-2 shows how to remove the stacking bracket front cover.
Lift and pull
Apply gentle
pressure
Apply gentle
pressure
ig.334.rh
Figure 5-2 Removing the stacking bracket front cover
2. Loosen and remove the eight M8 screws holding the stacking bracket to
the cabinet top, and retain.
WARNING
The stacking bracket can weigh as much as 15 kg (more if
CCB is contained in CCB basket). Observe the correct
lifting precautions when handling the stacking bracket.
3. Lift the stacking bracket off the cabinet.
4. Fit eight previously removed M8 screws to correct cabinet screw points
(see Figure 2-5). Tighten to correct torque (see
Installation &
Configuration: GSM-205-423
Site requirements and considerations).
5. Place the stacking bracket, with CCB basket (if previously removed), in a
box for storage, transport or safe disposal.
If the upper cabinet only is being decommissioned and an optional hood is
required after stacking bracket removal refer to
Installation & Configuration:
GSM-205-423
Fitting the optional hood.