Service Manual

GSM-205-423
Decommissioning Horizonmacro indoor
31st Oct 01
Installation & Configuration: Horizon macro indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 5–3
Eyebolt
positions and
safety
There are four eyebolt positions to enable lifting of a second cabinet from the
top of the first cabinet stacking bracket. Eyebolts are available from Motorola
for this purpose (part number 0386436N01 – Eyebolt, M8).
WARNING
The cabinet can weigh as much as 130 kg with stacking
bracket and CCB. Handle cabinets with extreme caution,
and in accordance with any national or regional health and
safety regulations.
Horizon
macro cabinets are heavy and should not be
installed without the use of lifting equipment unless
sufficient personnel are available to ensure that Health
and Safety regulations are not breached.
Eyebolts used to lift the cabinet must be of the collared
type, manufactured to CE conformity, and must have
sufficient safe working load to lift the cabinet, in
accordance with national or regional health and safety
regulations.
Motorola recommends the use of slings in conjunction with
hydraulic lifting apparatus for moving and positioning
Horizon
macro cabinets.
The four screw locations used for hood pins must NOT be
used for eyebolts.
In addition to these points, refer to and comply with any
local regulations that govern the use of lifting equipment.
For the subsequent use of eyebolts, there may be local regulations that govern
the use of lifting equipment and stipulate a test and/or examination regime. If
the eyebolts are to be used, ensure that all such regulations are met.
Eyebolts can be fitted into the four designated cabinet top panel locations,
shown in Figure 5-1, after removal of the screws. These locations are identified
with an eyebolt symbol and the word LIFT. The eyebolt locations are also used
for stacking bracket attachment.