Service Manual

GSM-205-423
Commissioning overview and test equipment
31st Oct 01
Inst. 4–2
Installation & Configuration: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W08-B
Test equipment
Table 4-1 provides details of the test equipment required to perform the
commissioning procedures in this chapter.
Table 4-1 Test equipment required for commissioning
Quantity Description Comments
1 IBM compatible portable
Personal Computer (PC) (486
DX2 or DX4 minimum)
The minimum requirements are:
TFT colour screen.
170 Mbyte hard drive
(minimum).
Minimum 4 Mbyte RAM or
recommended 8 Mbyte.
3.5 inch floppy drive.
Serial port.
CD-ROM drive (recommended)
PCMCIA (Type 2) compatible
slot.
Windows (3.1 running in 386
enhanced mode minimum)
loaded and running.
Battery power.
1 Commercial terminal emulator
software
PC PLUS or similar software
(suitable for PC being used)
1 Digital multimeter (must be
sensitive enough to measure
0.05 ohms)
Hewlett Packard E2378A or
equivalent
1 ESD protection kit
1 9-way male D-type to 9-way
female D-type adaptor
For PC to MCUF
Pin connections shown in
Figure 4-1.
1 PAT tester Insulation and earth tester