Manualshelf

Service Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsGSM 1900 Base Transceiver Station
241242243244245246247248249250
GSM-205-423
Hood or stacking bracket fit
31st Oct 01
Installation & Configuration: Horizon
macro
indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 2–13
Fitting the
stacking
bracket front
cover
The stacking bracket front cover is attached to the stacking bracket by four
locating clips. The procedure to fit the front cover is as follows:
1. Align the four locating clips on the front cover with the four square holes in
the front of the stacking bracket. Ensure that the cut out slot on each clip
is facing downward.
2. Press the cover against the stacking bracket, so that the cut out slot on
each locating clip engages with the bottom edge of each square hole. It
may be necessary to gently push in and down to ensure the cut out slots
are fully engaged and the cover securely in place.
Figure 2-8 shows the locating points for the stacking bracket front cover.
FRONT
COVER
STACKING
BRACKET
Figure 2-8 Fitting the stacking bracket front cover