Service Manual

GSM-205-423
Hood or stacking bracket fit
31st Oct 01
Inst. 2–12
Installation & Configuration: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W08-B
Fitting a
stacking
bracket
To fit a stacking bracket:
1. If an optional hood is fitted:
a. Lift hood by rear lifting edge, until free of the pins.
b. Unscrew and remove the four pins from the cabinet.
Store the pins with the hood.
2. Remove the eight (or four remaining) M8 screws form the cabinet top
panel as shown in Figure 2-7 and retain.
WARNING
The stacking bracket can weigh as much as 15 kg (more if
CCBs are contained in the CCB basket). Observe correct
lifting precautions when handling the stacking bracket.
3. Align the stacking bracket onto the cabinet, and fit the eight M8 screws.
Tighten to correct torque (see
Installation & Configuration: GSM-205-423
Site requirements and considerations).
4. Fit the front cover following the procedure detailed in Fitting the stacking
bracket front cover.
Figure 2-7 shows a stacking bracket fitted with optional CCB basket.
ig.268.rh
M8 HOLES (8) FOR
BOTTOM CABINET
ATTACHMENT.
M10 HOLES (4) FOR TOP CABINET
ATTACHMENT (IF REQUIRED)
CCB BASKET
(IF REQUIRED)
DETACHABLE
CCB BASKET BAR
REAR OF
BRACKET
Figure 2-7 View of stacking bracket with optional CCB basket installed