Service Manual

GSM-205-423
Hood or stacking bracket fit
31st Oct 01
Installation & Configuration: Horizon macro indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 2–11
Fitting the
optional hood
The hood is held in place by four pins. To fit the hood:
1. Locate the four top panel M8 screws to be replaced by hood pins, as
shown in Figure 2-7, and remove.
2. Screw the four pins into the cabinet top panel. Tighten to correct torque
(see
Installation & Configuration: GSM-205-423 Site requirements and
considerations).
3. Align the hood with the back pins, then lower the hood onto the pins, and
press firmly into place.
Figure 2-6 shows a top view of the hood as seen when on the cabinet:
ig.333.rh
LIFTING EDGE
HOOD
TOP SECTION OF
CABINET DOOR
Figure 2-6 Hood view when placed on top of cabinet