Service Manual

GSM-205-423
Hood or stacking bracket fit
31st Oct 01
Inst. 2–10
Installation & Configuration: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W08-B
Hood or stacking bracket fit
Introduction to
hood and
bracket fit
If required, the optional hood or stacking bracket are fitted at this stage.
To change from an existing hood to a stacking bracket, the pin locations for the
hood are used by removing the pins before fitting the stacking bracket screws.
Similarly, if replacing a stacking bracket with the optional hood, the appropriate
stacking bracket securing screws are replaced with the hood pins (see
Figure 2-5).
Diagram of pin
location points
on cabinet top
Figure 2-5 shows the eight screw positions used by the stacking bracket,
including the four positions also used for hood pins.
REMOVE SCREWS FOR
STACKING BRACKET ONLY
REMOVE SCREWS FOR
HOOD and STACKING
BRACKET
REMOVE SCREWS FOR HOOD
and STACKING BRACKET
REMOVE
SCREW FOR
STACKING
BRACKET
ONLY
REMOVE
SCREW FOR
STACKING
BRACKET
ONLY
FIT PIN FOR
HOOD
FIT PIN FOR
HOOD
FIT PIN FOR
HOOD
FIT PIN FOR
HOOD
Figure 2-5 Hood pin and stacking bracket screw positions