Service Manual

GSM-205-423
Equipment delivery and unpacking
31st Oct 01
Inst. 2–6
Installation & Configuration: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W08-B
Removing the cabinet from the crate base
WARNING The cabinet can weigh up to 130 kg if fully equipped.
Handle each cabinet with extreme caution, and in
accordance with local health and safety regulations.
To remove the cabinet from the crate base pallet:
CAUTION
Care must be taken to avoid damaging the cabinet in any
way, especially by scratching the outer surfaces.
1. Carefully cut open the sealed barrier bag containing the cabinet.
2. Use straps attached to the plywood base holding the cabinet, to lift cabinet
over the delivery pallet and foam packing pieces.
3. Remove the desiccant bag from the cabinet.
4. Inspect the equipment immediately for damage. Report the extent of any
damage to the transport company.
The cabinet is now unpacked.
Safe disposal of
packing
material
The packing material used by Motorola is non-returnable and should be
disposed of safely.
CTU allotted
slot retention
CTUs are supplied already fitted in the cabinet, with Tx cable correctly attached
by Motorola. CTUs must remain in the allotted slots for Motorola calibrations to
be valid.