Service Manual

GSM-205-423
Equipment delivery and unpacking
31st Oct 01
Installation & Configuration: Horizon macro indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 2–5
Equipment
module
packaging
The equipment modules are supplied already fitted into the cabinet. The only
exception to this is the plinth, supplied in a separate package. The plinth is
attached to the side of the main package to enable preparation work to proceed,
using the plinth, without opening the main cabinet package. This keeps the
cabinet protected during initial preparation.
The optional hood is supplied in a separate package.
Unpacking the
crate, plinth
and cabinet
The following describes the procedure for unpacking the equipment.
NOTE
It is recommended that the installer read through the
following procedure before starting to unpack and install
the equipment.
Tools
Use the following tools to dismantle the crate and unpack the cabinet.
 Claw hammer (or similar levering device).
 Knife.
Obtaining plinth base
To obtain the plinth:
1. Cut the plastic banding that secures the crate.
2. Remove separate plinth package, and deliver to site for site preparation if
required separately.
Delivery and dismantling of shipping crate
To deliver and dismantle the shipping crate:
1. Deliver remaining cabinet equipment to site in its original packaging.
NOTE
The packing material used by Motorola is non-returnable
and should be disposed of safely.
2. Lift the lid free of the crate.
3. Lift out cardboard protective pieces.
4. Lift the box over the cabinet.