Service Manual

GSM-205-423
Visiting the site
31st Oct 01
Installation & Configuration: Horizon macro indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 1–13
Waste material
on site
Clear waste material from the site on completion of the job, unless otherwise
indicated by the customer.
WARNING
Do not burn waste material, as packaging might give off
toxic gasses.
Rural sites
It is the responsibility of the senior member of the team to ensure that all
personnel on site are aware of all applicable national and regional
environmental regulations or codes of practice and, especially with respect to
water authority sites, any relevant health regulations.
Adhere to these points:
 Guard against all risk of fire.
 Fasten all gates (remember site visits could be traced back if a complaint
is made).
 Leave no litter.
 Drive carefully on country roads and observe speed restrictions at all
times.
 Keep to the paths/tracks across farm land.
On site safety
All personnel must:
 Ensure that under no circumstances should anyone move cabinets without
assistance. Cabinets must be safely positioned at all times.
 Wear supplied safety helmets when antenna or overhead work is in
progress, and when local regulations require them.
 Wear supplied safety goggles and dust masks when drilling. This is
particularly important when drilling overhead ironwork.
 Wear supplied ear protectors while drilling is in progress.
 Wear approved safety footwear when moving heavy equipment.
Stop any work that you are supervising should any person in your team not be
properly protected, or be unaware of safety requirements.
When installing cable ties, even temporarily, cut the excess or tail properly. This
is to prevent sharp edges inflicting injury when not cut flush with the locking
edge.