Service Manual

GSM-205-423
Visiting the site
31st Oct 01
Inst. 1–12
Installation & Configuration: Horizon macro indoor
CONTROLLED INTRODUCTION
68P02902W08-B
Visiting the site
Site visit
instructions
When preparing to do work at a site and upon arrival, follow the instructions
provided in this section.
Before leaving
for the site
Before leaving for the site:
1. Check that team members have adequate test equipment, tools, and
hardware to complete the tasks. Check for any special requirements.
2. Contact the person in charge of the building to advise of the team’s
estimated time of arrival and the expected duration of their stay on the
site. Usually the logistics will have already been arranged, but it is good
practice to check that the information was received.
3. Ensure that the team read the site access details on each visit to a site as
local regulations may change.
Arrival at site
When entering any site:
1. Do not enter the site before contacting the communications site manager.
Obtain the following information from the building contact:
– Local regulations.
– Parking instructions.
– Waste material removal instructions.
– Directions to canteen facilities (if available).
2. Enter the site.
3. Check for building alarms, for example, intruder alarms, that may have
been activated by entry. If fitted, disable the CO2 gas systems, and any
other alarms activated by entry.
4. Read any local instructions provided.
Leaving the site
When leaving a site:
1. Enable the CO2 gas system, if fitted, and any alarms that were disabled.
2. Contact the local site manager to announce the team’s departure.
3. Sign out of the building as necessary