Service Manual

GSM-205-423
Introduction to installation
31st Oct 01
Installation & Configuration: Horizon macro indoor
68P02902W08-B
CONTROLLED INTRODUCTION
Inst. 1–1
Introduction to installation
Manual scope
This category (GSM-205-423) covers installation and commissioning for the
cabinet, arranged in the following chapters:
Chapter 1 Introduction and site preparation
General information, safety instructions and information about tools needed to
install the equipment.
Describes the procedures to be followed for initially preparing the site and
installing the necessary ducting and plinths.
Chapter 2 Installation of indoor cabinet
All the procedures necessary to install the cabinet ready for operation and an
overview about the different configurations available.
Chapter 3 Interoperability
Describes interoperability between the Horizon macro indoor BTS and earlier
Motorola BTS products.
Chapter 4 Commissioning of indoor cabinet
All procedures necessary to enable the cabinet to be fully operational.
Chapter 5 Decommissioning of indoor cabinet
All procedures necessary to decommission the cabinet.
NOTE
For hardware optimization and base site integration, refer
to
Installation and Configuration: BSS Optimization:
(GSM-100-423)
.
Software
requirements
The GSM/EGSM900 and DCS1800 BTSs require software release GSR4 (or
later) in the network.
The GSM850 and PCS1900 BTSs require software release GSR5.1 (or later) in
the network.