Manualshelf

Service Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsGSM 1900 Base Transceiver Station
151152153154155156157158159160
GSM-205-323
Feedthrough plate
31st Oct 01
Technical Description: Horizon
macro
indoor
68P02902W07-B
CONTROLLED INTRODUCTION
Tech. 5–35
Feedthrough plate
Purpose of
feedthrough
plate
The feedthrough plate converts the normal SMA connector from the CTU to an
N-type connector. Each feedthrough plate has a pair of these converters, one
for each of two CTUs. The top N-type connectors are used to connect with
either a CCB, or at the (optional) third Tx port on the top of a DDF Tx block.
The plate is attached to the base of the top panel basket using six M4 screws.
View of
feedthrough
plate
Figure 5-20 shows a top view of a feedthrough plate.
N-TYPE
CONNECTORS FOR
CCBs OR DDFs
SMA CONNECTORS BENEATH
FROM CTUs
M4 HOLES FOR
ATTACHMENT
Figure 5-20 View of feedthrough plate
Feedthrough
plate
connectors
Each feedthrough plate connects to:
The Tx outputs of two CTUs, using SMA connectors.
Tx inputs of CCBs, or DDFs, using N-type connectors.