Service Manual

GSM-204-523
Replacing the door on the auxiliary equipment housing
31st Oct 01
Maint. 4–8
Maintenance Information: Horizon macro outdoor
CONTROLLED INTRODUCTION
68P02902W04-A
Replacing the door on the auxiliary equipment housing
Removing the
cabinet door
To remove the cabinet door:
1. Unscrew the M6 nut, plain washer and star washer which secures the door
earth cable to the cabinet body.
2. Unscrew the wind stop from the cabinet.
3. Remove the circlips from the bottom of the hinge pins.
WARNING
The cabinet door weighs 15 kg. Handle with care and
observe proper lifting precautions.
4. Support the door and remove the two hinge pins by pulling their lugs in the
required direction, using long nose pliers.
5. Remove the door and place safely to one side.
Fitting a
replacement
door
To fit a replacement door:
1. Support the door in position, so that the hinges line up.
2. Insert the two hinge pins fully into the hinges.
3. Fit the circlips into the recesses in the bottom of the hinges.
4. Screw the wind stop to the cabinet.
5. Attach the door earth cable to the cabinet using the star washer, plain
washer and M6 nut. Tighten to the correct torque (see Overview of FRU
replacement procedures in Chapter 2 of this category).