Service Manual

GSM-204-523
Replacing the lid on the auxiliary equipment housing
31st Oct 01
Maintenance Information: Horizon macro outdoor
68P02902W04-A
CONTROLLED INTRODUCTION
Maint. 4–7
Fitting a new lid
To fit a new lid:
1. Support the new lid in position, so that the hinges line up.
2. Insert the two hinge pins fully into the hinges.
3. Screw the mechanical stay to the lid.
4. Fit the circlips into the recesses in the hinges.
5. Attach the lid earth cable to the cabinet using the star washer, plain
washer and M6 nut. Tighten to the correct torque (see Overview of FRU
replacement procedures in Chapter 2 of this category).
6. Mount the power distribution box in position on the inside of the lid and
tighten the eight M4 nuts.
7. Switch on the circuit breakers on the front of the power distribution box
and then close the lid and the cabinet door.
8. Switch on the EXT BATT circuit breaker on the dc circuit breaker panel in
the main cabinet.
The procedure for fitting the new lid is now complete.