Service Manual

GSM-204-523
Replacing the lid
31st Oct 01
Maint. 3–6
Maintenance Information: Horizon macro outdoor
CONTROLLED INTRODUCTION
68P02902W04-A
Replacing a lid
Removing a faulty lid
To remove the lid proceed as follows:
1. Unscrew the M6 nut and star washer which secures the lid earth cable to
the cabinet.
2. Remove the circlips from the hinge pins.
3. Unbolt gas strut from the lid.
WARNING
The cabinet lid weighs 15 kg. Handle with care and
observe proper lifting precautions.
4. Support the lid and unscrew the mechanical stay from the lid.
5. Remove the three hinge pins by pulling their lugs in the required direction,
using long nose pliers.
6. Remove the lid and place safely to one side.
Fitting a replacement lid
To install a replacement lid proceed as follows:
1. Support the lid in position, so that the hinges line up.
2. Insert the three hinge pins fully into the hinges.
3. Screw the mechanical stay to the lid.
4. Bolt the gas strut to the lid.
5. Fit the circlips into the recesses in the hinges.
6. Attach the lid earth cable to the cabinet using the M6 nut and star washer.
Tighten to the correct torque (see Overview of FRU replacement
procedures in this chapter).