User's Manual Part 2
Module Front Panel LED Indicators and Connectors – continued
08/01/2001
6-33
1X SCt4812ET Lite BTS Optimization/ATP
PRELIMINARY
BBX2 LED Status
Combinations
PWR/ALM LED
The BBX module has its own alarm (fault) detection circuitry that
controls the state of the PWR/ALM LED.
The following list describes the states of the bi-color LED:
S Solid GREEN – INS_ACT no alarm
S Solid RED Red – initializing or power-up alarm
S Slowly Flashing GREEN – OOS_ROM no alarm
S Long RED/Short GREEN – OOS_ROM alarm
S Rapidly Flashing GREEN – OOS_RAM no alarm
S Short RED/Short GREEN – OOS_RAM alarm
S Long GREEN/Short RED – INS_ACT alarm
MCC24 LED Status
Combinations
The MCC24 module has LED indicators and connectors as described
below. See Figure 6-4. Note that the figure does not show the connectors
as they are concealed by the removable lens.
The LED indicators and their states are as follows:
PWR/ALM LED
S RED – fault on module
ACTIVE LED
S Off – module is inactive, off-line, or not processing traffic.
S Slowly Flashing GREEN – OOS_ROM no alarm.
S Rapidly Flashing Green – OOS_RAM no alarm.
S Solid GREEN – module is INS_ACT, on-line, processing traffic.
PWR/ALM and ACTIVE LEDs
S Solid RED – module is powered but is in reset or the BCP is inactive.
MMI Connectors
S The RS–232 MMI port connector (four-pin) is intended to be used
primarily in the development or factory environment but may be used
in the field for debugging purposes.
S The RJ–11 ethernet port connector (eight-pin) is intended to be used
primarily in the development environment but may be used in the field
for high data rate debugging purposes.
. . . continued on next page
6