User's Manual Part 3

Index – continued
Mar 2001
SCt4812T CDMA BTS Optimization/ATP
DRAFT
Index-7
Span Parameter Configuration
set, procedure, 5-4
verification, procedure, 5-3
Span Problems, no control link, 6-27
SPANS LED, GLI2, 6-23
Spectral Purity Transmit Mask ATP, 4-6
Spectral Purity TX Mask, 4-5
Spectrum Analyzer, 1-11, 3-58, 3-59
Spectrum Analyzer , HP8594E, 3-43
STATUS LED, GLI2, 6-23
SYNC Monitor Connector, CSM, 6-22
System Connectivity Test, HP8921A, F-2
T
T1
isolate BTS from the T1 spans, 3-4
span connection, 5-8
Test data sheets
AMR CDI Alarm Input Verification, A-17
BTS redundancy/alarm tests, A-16
general optimization checklist, A-4
GPS receiver operation, A-5
initial power tests, A-3
LFR receiver operation, A-6
LPA
convergence, A-8
IM Reduction, A-7
pre–power tests, A-3
preliminary operations, A-2
RX antenna VSWR, A-17
site checklist, A-2
TX antenna VSWR, A-16
TX BLO
Offset/Power Output Verification, A-9
Power Output Verification, A-14
Test Equipment
Automatically Selecting, 3-55
Calibrating, 3-56
Connecting test equipment to the BTS, 3-43
Manually Selecting, 3-54
Reference Chart, 3-44
Selecting, 3-54
verification data sheets, A-1
VSWR, G-1
Test Equipment Setup, 3-43
GPS & LFR/HSO, 3-34
HP PCS Interface, F-7
RF path calibration, 3-67
Test Matrix, C-4
ATP optimization, C-2
Test Set, Calibration, 3-53
Timing Reference Cables, 1-9
Top Interconnect Plate, 1-19
Troubleshooting
BBX Control Good – No (or Missing) Span Line
Traffic, 6-16
BLO Calibration Failure, 6-6
C–CCP Backplane, 6-13, 6-14
Calibration Audit Failure, 6-7
Code Domain Power and Noise Floor Measurement
Failure, 6-9
Code Download Failure, 6-4
Communications Analyzer Communication Failure,
6-3
CSM Checklist, 6-11
Data Download Failure, 6-4
DC Power Problems, 6-18
Device Enable (INS) Failure, 6-5
Login Failure, 6-2
MGLI2 Control Good – No Control over AMR,
6-16
MGLI2 Control Good – No Control over
Co–located GLI2, 6-15
Miscellaneous Failures, 6-5
Multi–FER Failure, 6-10
No BBX Control in the Shelf – No Control over
Co–located GLI2s, 6-16
No DC Input Voltage to any C–CCP Shelf Module,
6-19
No DC Input Voltage to Power Supply Module,
6-18
No GLI2 Control through Span Line Connection,
6-15
No GLI2 Control via LMF, 6-15
No MCC Channel Elements, 6-17
Power Meter Communication Failure, 6-2
Rho and Pilot Time Offset Measurement Failure,
6-8
Span Problems, no control link, 6-27
TX and RX Signal Routing, 6-19
TX Mask Measurement Failure, 6-8
TSU NAM
Parameters, 3-78