User's Manual Part 3

Troubleshooting: Download
DRAFT
SCt4812T CDMA BTS Optimization/ATP
Mar 2001
6-4
Cannot Download CODE to
Any Device (card)
Follow the procedure in Table 6-4 to troubleshoot a code download
failure.
Table 6-4: Troubleshooting Code Download Failure
 Step Action
1 Verify T1 is disconnected from the BTS.
2 Verify the LMF can communicate with the BTS device using the Status function.
3 Communication to the MGLI2 must first be established before trying to talk to any other BTS
device.
The MGLI2 must be INS_ACT state (green).
4 Verify the card is physically present in the cage and powered-up.
5 If the card LED is solid RED, it implies hardware failure.
Reset the card by re-seating it.
If the LED remains solid red, replace with a card from another slot & retry.
NOTE
The card can only be replaced by a card of the same type.
6 Re-seat the card and try again.
7 If BBX reports a failure message and is OOS_RAM, the code load was OK.
8 If the download portion completes and the reset portion fails, reset the device by selecting the
device and Reset.
Cannot Download DATA to
Any Device (Card)
Perform the procedure in Table 6-5 to troubleshoot a data download
failure.
Table 6-5: Troubleshooting Data Download Failure
 Step Action
1 Re-seat the card and repeat code and data load procedure.
6