User's Manual Part 3

Prepare to Leave the Site – continued

Mar 2001

5-5

SCt4812T CDMA BTS Optimization/ATP

DRAFT

Table 5-4: BTS Span Parameter Configuration

Step Action

4 Repeat steps 1 through 3 for all remaining GLIs.

5 Exit the GLI MMI session and HyperTerminal connection by selecting File from the connection

window menu bar, and then Exit from the dropdown menu.

ÂÂÂÂÂÂÂ

FW00344

9–PIN TO 9– PIN

RS–232 CABLE

NULL MODEM BOARD

(PART# 8484877P01)

RS–232 CABLE

FROM LMF COM1

PORT

MMI SERIAL PORT

GLI BOARD

Figure 5-2: MGLI2/SGLI2 MMI Port Connection

Set BTS Site Span

Configuration

Perform the procedure in Table 5-5 to configure the Span Framing

Format and Line Build Out (LBO) parameters. ALL MGLI2/SGLI2

boards in all C–CCP shelves that terminate a T1/E1 span must be

configured.

Perform the following procedure ONLY if span

configurations loaded in the MGLI2/GLI2s do not match

those in the OMCR/CBSC data base, AND ONLY when the

exact configuration data is available. Loading incorrect

span configuration data will render the site inoperable.

IMPORTANT