User's Manual

Cabinet Cabling

– continued

DRAFT

4812ET RF and Power Cabinet Hardware Installation Manual

Apr 2001

V04.03

Installation Procedure

Table 5-9 details the step–by–step procedure on installing the RGPS

cabling.

Table 5-9: RGPS Cable Install Procedure

Step Action

1 Route the twisted pair cable through the previously installed conduit to the RF Cabinet I/O area, and

to the punch block through the rubber boot in the floor of the I/O area (See Figure 5-6). Refer to

Figure 5-1 for the recommended locations.

NOTE

The rubber boot is sized to seal a cable with an outer diameter of either 1/4” or 1/2”, if a different

sized cable is used heat/cold shrink or other means may be required to ensure a good seal. A tie wrap

or hose clamp must be used to ensure a good seal around the cables at the boot.

2 Connect the RGPS pairs from the cable to the punch block (using only the recommended 110 style

punch tool CGDS237744 or equivalent) per the pin call–outs in Table 5-10.

3 Strain relief the cable by tie wrapping it to the punch block mounting bracket as shown in Figure 5-5

The RGPS cable is comprised of 6 twisted pairs of wires.

For proper RGPS operation, each BLACK wire in this

cable is unique and must be paired with it’s proper mate.

NOTE

Punch Block for the Remote GPS (RGPS)

Table 5-10: Punch Block for the Remote GPS

Punch Block

Pin Number

Signal Name Wire Color

42T GPS_POWER_1+ BLUE

42R GPS_POWER_1– BLACK/BLUE

43T GPS_POWER_2+ YELLOW

43R GPS_POWER_2– BLACK/YELLOW

44T GPS_RX+ WHITE

44R GPS_RX– BLACK/WHITE

45T GPS_TX+ GREEN

45R GPS_TX– BLACK/GREEN

46T TDR+ RED

46R TDR– BLACK/RED

47T GPS_1pps+ BROWN

47R GPS_1pps– BLACK/BROWN