User's Manual

Cabinet Mounting
– continued
DRAFT
SC
TM
4812ET RF and Power Cabinet Hardware Installation Manual
Apr 2001
V04.03
70
Table 4-2: Concrete Pad Mounting
Step Action
4 Remove the four (4) eye–bolts (see Figure 4-2) on the top of
the cabinet, replace them with the bolts and washers supplied
with the installation hardware using a 24 mm (15/16”) hex
driver. Torque to 80 N–m (60 ft–lbs).
5 Install the wiring as described in Chapter 5 of this manual.
The isolation washers supplied in the hardware installation
kit are provided to give the installer the option of
electrically isolating the cabinet should the situation
require it. The use of the washers is not a requirement.
The grounding of each site is unique, and the isolation of
the cabinet is a site specific decision.
NOTE
Figure 4-2: Cabinet Mounting Brackets
Eye–Bolt
Use supplied M12 washers when fastening the mounting
brackets to the cabinet.
NOTE
. . . continued on next page
4