User's Manual

Cabinet Mounting

– continued

Apr 2001

V04.03

4812ET RF and Power Cabinet Hardware Installation Manual

DRAFT

Figure 4-1: Front Cabinet Door Hinge (Close-up View)

Loosen this screw to remove door

(Top and Bottom Hinges)

Existing Concrete Pad

Mounting Procedure

Mounting the cabinet on a pre–existing concrete pad requires that the

mounting holes be drilled using the procedures in Chapter 2 of this

manual. Follow the procedures in Table 4-2 to mount each cabinet.

Table 4-2: Concrete Pad Mounting

Step Action

1 Fasten mounting brackets (see Figure 4-2) onto cabinet with

M12 bolts (supplied in installation hardware). Do NOT torque

the bolts yet. Align the cabinet over the mounting holes.

! CAUTION

Do NOT use the cabinet doors as a hand hold to move the

cabinet around, this could damage the door hinges

2 Install the anchor bolts in the four (4) mounting locations in

the mounting brackets attached to the cabinet base. Tighten

the bolts to proper torque recommended by the manufacturer.

n WARNING

Motorola recommended anchor bolts must be used to assure

safety in the event of an earthquake (CGDS97400036). These

bolts should be tightened to 80 N–m (60 ft–lbs.).

3 Tighten the M12 bolts attaching the mounting brackets to the

cabinet, torque to 135 N–m (100 ft–lbs) with a 19mm (3/4”)

torque wrench.

. . . continued on next page