User's Manual

Apr 2001
V0G.01
SC
TM
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
177
Appendix G: SC 4812ET – SC 4812ET
Companion Frame Installation
This section includes...
Scope and Introduction 177. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Tools Needed 177. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Required documents 177. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing an EMPC in a SC 4812ET RF Starter Frame 178. . . . . . .
Connecting an SC 4812ET Starter BTS to an Companion Frame 178
Tables
Table G-1: Installing an EMPC in the SC 4812ET Starter Frame 178
Table G-2: Connecting 4812ET RF Starter to RF Companion 178.
Figures
Figure G-1: RX Expansion Cabling of 4812ET to 4812ET BTS 179
Scope and Introduction
The purpose of this information is to provide instructions on how to
install a SC 4812ET to SC 4812ET companion frame configuration. This
procedure assumes that the SC 4812ET has been previously installed,
optimized, tested and is in operation.
Interconnection ports are included in the SC 4812ET to SC 4812ET
inter–cabinet cabling diagram (see Figure G-1).
Tools Needed
– 10 mm Nut Driver
– TORX T15 Screw Driver
– SMA torque wrench or 5/16” wrench if not available
– Type N torque wrench or 11/16” wrench if not available.
Required documents
– SC 4812ET RF and Power Cabinet Installation manual (Motorola
part number 68P64114A22).
– SC 4812ET RF Cabinet Optimization/ATP manuals (Motorola part
number 68P64114A23 and 68P64114A42).
– SC 614T 2nd Carrier Optimization/ATP manual (Motorola part
number 68P64113A61)
G