User's Manual

SC 4812ET – SC 614/SC 614T Companion Frame Installation
– continued
Apr 2001
V0E.02
SC
TM
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
159
– For your convenience the BTS is shipped with center
punches in each of these locations
– Use of a hole saw is NOT recommended due to the
variation of the diameter and quality of the resulting
hole. A hole that is too big or oblong can result in a
cable termination that won’t seal.
NOTE
Figure E-1: Views of BTS Side Walls below Shroud
RF
DC
EARTH
GND
RGPS RGPS
T1/E1
SPAN
RIGHT SIDE
LEFT SIDE
158 mm
(6–3/16”)
69 mm
(2–11/16”)
158 mm
(6–3/16”)
69 mm
(2–11/16”)
– A –
RF
RF
MULTICARRIER – HSO
RF
AC
EARTH
GND
RGPS
RGPS
T1/E1
SPAN
RF
RF
MULTICARRIER – HSO
– A –
RF RF RF
RF RF RF
RF RF RF
RF RF RF
– Cable entry hole locations are at the installers option.
The diagrams shown here is only intended to be used
as a guideline. Punch only entry holes as are
applicable.
–“Datum A” represents the bottom of the BTS itself.
The rubber pad and the bottom cover are below
“Datum A”.
NOTE
. . . continued on next page
E