User's Manual

Introduction
– continued
Apr 2001
V02.03
15
SC
TM
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
Chapter 4 – “Cabinet Mounting” – This chapter covers cabinet
preparation, rooftop (elevated) and concrete pad mounting, and battery
installation.
Chapter 5 – “Cabinet Cabling” – This chapter contains procedures for
cabling the RF and Power Cabinet. This includes earth ground, alarm &
span line, RGPS, RF GPS, LFR, RF, AC power, DC power, and other
cabling considerations.
Chapter 6 – “What’s Next and Cleanup” – This chapter includes site
cleanup and a pre–optimization checklist.
Appendix A – “Installing RGPS”— This appendix covers the mounting
and installation of the RGPS hardware.
Appendix B – “Cabinet Specifications”— This appendix covers the
basic specifications of the SC 4812ET RF Cabinet and Power Cabinet.
Appendix C – “Installation Quickstart” – A quick reference quide to the
installation of the SC 4812ET BTS.
Appendix D – “SC 4812ET/SC 614 BTS DC Power Sharing” – This
appendix covers the instructions for powering both the SC 4812ET RF
Cabinet and the SC 614T BTS from one SC 4812ET Power Cabinet.
Appendix E – “SC 4812ET – SC 614/SC 614T Companion Frame
Installation” – This appendix covers the instructions for converting the
existing SC 614T site from a starter frame to an expansion frame.
Appendix F – “SC 4812ET to SC 4812ET DC Power Sharing” – This
appendix covers the instructions for cabling a SC 4812ET Power
Cabinet to two 4812ET RF Cabinets.
Appendix G – “SC 4812ET – SC 4812ET Companion Frame
Installation” – This appendix covers the instructions for connecting a
starter frame to an expansion frame.
Appendix H –“Installing RF GPS”
Appendix I – “Minimum Requirements for Customer purchased CSU”
Recommended
Documents
The following documents are recommended to perform the installation
of the cell site equipment:
S SC 4812ET CDMA Optimization (Motorola part number
68P09253A74)
S SC 4812ET Field Replaceable Unit (FRU) Identification Guide
(Motorola part number 68P09253A48)
1