Installation Instructions

BTS Software – continued

DEC 2000

7-27

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Table 7-14: Download/Enable MAWI

Step Action

1 If the ATP is going to be run, the MAWI has to have the same code load as the LMF CDF or the site

specific information cannot be loaded to MAWI (PN offset, etc.) for ATP to complete.

2 If downloading code, insure the LMF is logged into the BTS at 38400 Baud Rate for timely

download (20 minutes vs 2+ hours).

3 Click on the MAWI and select Device>Download Code.

A status report is displayed that confirms the change in device status. Click OK to close status

window.

4 Click on the MAWI and select Device>Download Data. A status report is displayed that

confirms the change in device status. Click OK to close status window.

5 Click on the MAWI and select Device>Enable to enable the MAWI. The MAWI changes to green

(INS–ACT test mode).

Cell Site Data File (CDF)

The Configuration Data File (CDF) includes the CDMA channel element

allocation plan. This plan indicates how each CDMA carrier is

configured, and how the paging, sync, traffic, and access channel

elements (and associated gain values) are assigned.

The CDF file also contains a table for the Effective Rated Power (ERP)

for each transmit antenna. Motorola System Engineering specifies the

ERP of a transmit antenna based on site geography, antenna placement,

and government regulations. Working from this ERP requirement, the

antenna gain, (dependent on the units of measurement specified) and

antenna feed line loss can be combined to determine the required power

at the BTS TX output.

Refer to the CDMA LMF Operators Guide; 68P64114A78

for additional information on the layout of the LMF

directory structure (including cdf file locations and

formats).

NOTE

Site equipage verification

If you have not already done so, use an editor to view the CDF, and

review the site documentation. Verify the site engineering equipage data

in the CDF to the actual site hardware.

If the current LMF or BTS binaries need to be installed on

the LMF PC, or for more information on viewing CDF

files, refer to the CDMA LMF Operators Guide;

68P64114A78.

NOTE