Installation Instructions

BTS Software

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

7-24

Objective

This objective of this procedure is to:

1. Install the LMF program.

2. Create a site specific BTS directory.

3. Start the LMF.

4. Login to the BTS

5. Update the BTS–specific CDF file.

6. Download and enable the MAWI

Install the LMF Program and

BTS Binaries

Install the LMF and BTS binaries on the PC to be used if they are not already

installed. Refer to the CDMA LMF Operator’s Guide, 68P64114A78 for

the installation procedure.

Create a Site–Specific BTS

Directory

Follow the steps in Table 7-11 to create a bts–

bts#

directory, to which

the bts–bts#.cdf, cbsc–1.cdf, bts–bts#.cal, and ATP

report files will reside.

Table 7-11: Create Site–Specific BTS Directory

Step Action

1 Use MS Windows Explorer to create a bts–# folder under the wlmf\cdma folder

(where # is the bts number).

2 Get the bts–#.cdf file and cbsc–#.cdf file from the CBSC and put a copy of

the files in the wlmf\cdma\bts–# folder. Refer to the LMF help screens or the

CDMA LMF Operator’s Guide, 68P64114A21 for the copy file procedure.

Start the LMF and Login to the

BTS

Use the following procedure in Table 7-12 to start the LMF and login to

the BTS.

Prerequisites

1. A bts–# folder with a correct CDF and CBSC file exists.

2. The LMF notebook is correctly set up and connected to the BTS.

Refer to Figure 7-7.