Installation Instructions

Attaching Back Fin Cover to Unit
DEC 2000
6-5
SCt300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
Objective
The objective of this procedure is to attach the back fin cover to the
PicoCell and MicroCell units. The front fin cover is mounted to the unit
after the unit is mounted to the mounting bracket.
When to Use the Fin Covers
The fin covers should always be used in an indoor application.
Procedure
Attach the rear fin cover to the unit by following the procedures in
Table 6-1 and the information in Figure 6-4.
Table 6-1: Procedure to Attach Rear Fin Cover to Units
Step Action
1 Install back fin cover prior to placing unit on the mounting
bracket.
2 Center fin cover on the fins of the unit. See Figure 6-4 for
snap locations.
3 Align snap with center tab on fins.
4 Push fin cover into place.
Figure 6-4: Attaching Back Fin Cover to Unit (Picocell Shown)
LOCATION OF SNAPS TO ATTACH
FIN COVER TO UNIT
PICOCELL FINS
6