Installation Instructions

Test Equipment and LMF Connection – continued

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

7-10

Table 7-3: Interfacing test equipment to the BTS

Step Action

3 Connect a BNC/BNC cable between the following points:

– BNC to one end of the BNC “T.”

– BNC to the EXT TRIG port on the rear panel of the Advantest R3465.

4 Connect the BNC “T” to the EVEN SEC/SYNC IN port of the Advantest R356IL.

5 Verify the R3561 and R3465 rear panel connections are in place (These are common connections and

should already be installed):

– Serial cable between 3465A rear panel SERIAL I/O port and R3561 SERIAL I/O port.

– SMA cable between 3465A rear panel 1ST LO OUT port and R3561 LOCAL IN port.